The current date and time will not be affected.
Turn the dial to Seasonal Adjust.Press and hold the left and right arrow buttons at the same time for at least 3 seconds. Until you see the word “CLEARED” on the screen.Turn the dial back to AUTO RUN. Your ESP-Me is now restored to the factory default settings.
How long should sprinklers run in each zone?
Water Thoroughly: Rotor zones should run for about 30-40 minutes per zone and spray zones 10-15 minutes per zone.
How long should I run my Rainbird sprinkler system?
Keep It Balanced. Put measuring cups in various places around your lawn and run the sprinklers for 15 minutes. This will give you an idea of how much water the grass is getting and where. You’re looking for about one to two inches—depending on the soil—evenly distributed.
How do I reset my sprinklers?
How to Reset a Sprinkler System
Turn the control dial to the “off” position.Press the “next” button to access the clear-memory feature. Press and hold the “off” button until the display stops blinking.Turn the control dial to the “run” position.Press and hold down the “minus” arrow and “prog” buttons simultaneously.
How do I reset my Rainbird ESP 6?
Try disconnecting the power and the back up battery, then press and hold the manual start / advance button for about 10 seconds to dissipate any residual power in the controller. Reconnect the power again to see if this has reset the controller.
How do I reset my Rain Bird WiFi module?
Reset the WiFi module. While plugged in, press and hold the button on the WiFi module for 5 seconds. After this reset is complete it will be necessary to set up the WiFi module again in the Rain Bird App as if it was new.
ncG1vNJzZmivp6x7or%2FKZp2oql2esaatjZympmeYpMRusM5moGaqlaiytXnMsmSrmZmjeqO10Z1knKeeqb%2BwuMueqWabmJqwrHnIrWSoraRitbDDjK2mZqiipLSzrcxmqZqhnmKvqr7DZqqpqpmjuK2x0Waqsqukmrpw